fuel flow totalizer

Brianrv-4

New Member
Joined
May 10, 2007
Messages
2
While installing my new flitedek 180 I also had a fuel flow gizmo that a card attached to it with numbers on it. After reading the installation guide I put this card away where I could input the values later. Well I have misplaced it and now I was wondering is there a default value I can start from?
 

dynonsupport

Dynon Technical Support
Staff member
Joined
Mar 23, 2005
Messages
13,226
You can start with a K-factor of 30,000 and then iterate over fill-ups as described in the installation guide.
 
Top