DaveJnr
New Member
I'm hoping somebody out there can give me a little assistance. I'm sure this is a trivial matter but I would just like your oppinion before I make a mistake.
I am constructing a TL-200 Sting using a very sparse build manual which does not go into any detail regarding matters electrical. The factory supplied fuel sender uses a mechanical float arm to register the fuel quantity. My dilema is that it has four electrical connections. Can somebody explain what these four connections are and how I connect this sender to my Dynon D120. I am assuming one is ground; one is 12v and the other two are the the ones connected to the dynon.
Thanks
I am constructing a TL-200 Sting using a very sparse build manual which does not go into any detail regarding matters electrical. The factory supplied fuel sender uses a mechanical float arm to register the fuel quantity. My dilema is that it has four electrical connections. Can somebody explain what these four connections are and how I connect this sender to my Dynon D120. I am assuming one is ground; one is 12v and the other two are the the ones connected to the dynon.
Thanks