General Purpose Thermocouple Pin 27/28

Scott

New Member
Joined
Apr 4, 2007
Messages
43
The EMS has pins 27/28 for monitoring a general purpose thermocouple. Hardware is there, but manual says its to be supported in the firmware soon.

Is this supported yet?

Scott
 

Scott

New Member
Joined
Apr 4, 2007
Messages
43
Its a simple question Dynon..... I'd like to know since I installed a probe and ran the wire as instructed in the manual in anticipation of a follow through... :)

Are you doing what you promised or not? :-?

Scott
 

dynonsupport

Dynon Technical Support
Staff member
Joined
Mar 23, 2005
Messages
13,226
Sorry for the delayed response - the people who normally take care of the forum are away at Oshkosh. We're only online intermittently.

The EMS thermocouple input has not yet been implemented. It's still on our list of things to polish off.
 

Scott

New Member
Joined
Apr 4, 2007
Messages
43
If you need a beta tester I'm willing and ready.

It would be used for Turbine inlet Temperature.

Scott
 
Top