How Do I add Additional Fuel Level Settings

[N74846]

I recently installed a new fuel tank and did a re-calibration. I saved the old readings for reference. For some reason I have less increments than the first calibration. As I know the correct voltage=gals settings I would like to add these manually to the existing profile without having to do a full re-cal.

Is there a method in the EDIT mode to add an additional voltage-gals level?

 

[Dynon]

Not in the UI. But, if you export your settings file, you can edit the .dfg and then re-import it to add points. You'll find the calibrations in the "user_cal" areas. Make sure you edit the ones that are named as your fuel tanks are.

 

[N74846]

I'll give it try, thx.