I'd like to eliminate the ID825 indicator that goes with the Narco Mk12D+. The HS34 has inputs/outputs that don't fully overlap with the Mk12D's pinouts. On the Mk12D, there are Resolver pins for Arinc C, D, E,F,H,G. There is also left/rt and up down for AP and glideslope and of course the flags. There does not seem to be any resolver A and B pins. Is there a combination that might work?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
HS34 and Narco Mk 12D+
- Thread starter MarcEZ
- Start date
- Joined
- Mar 23, 2005
- Messages
- 13,226
The HS34 will work fine with that radio. We have a bit of a documentation error, and our pins aren't labeled accoring to industry convention.
Here's a chart of how to hook it up:
http://wiki.dynonavionics.com/Generic_Analog_Wiring
Here's a chart of how to hook it up:
http://wiki.dynonavionics.com/Generic_Analog_Wiring
ahouse
New Member
I would also like to remove the 824 Indicator when I install the Skyview in my RV-4. Is there a pin to pin wiring chart for the Narco MK12D to the HS34? It is connector P102 on the Narco. Or do the pins (C,G,H,D,E,F) in the Generic Analog Wiring chart accomplish everything? If so, there is not a pin G on P102.
- Joined
- Mar 23, 2005
- Messages
- 13,226
Unfortunately, we do not have any additional documentation available for the HS34 analog inputs. Also, due to compatibility issues that we discovered in the years since the HS34's release, the analog interface is not considered supported at this time. If you wish to return your HS34 for a refund, give us a call at 425-402-0433.