inclination angle setup and when to do

Joined
Mar 23, 2005
Messages
134
Hi there, just reread the installation guide 4-2, it says:
"Note, that this procedure needs to be done only once; after a magnetic calibration, moving the aircraft to another location does not require....."

This is true if moving is flying or the Dynon is on right? So if I transfer my airplane from Switzerland to Australia it will calculate the changes, if I ship the airplane (powerd off) I have to redo it?

br Werner
 

dynonsupport

Dynon Technical Support
Staff member
Joined
Mar 23, 2005
Messages
13,226
It does not matter if the unit is on or off as it is moved. We still only need the inclination angle during calibration. You only need to set it before doing a calibration.
 
Joined
Mar 23, 2005
Messages
134
Ok that makes it a 100% clear, enter/check before calibration ::) Damn and I thought I had another good reason to fly to there :mad:

Thx a lot

Werner
 
Top