Jabiru 3300 Sensor Alarm Settings?

[Graham711]

Jabiru 3300 EMS Setup?
Hi,

Has all the Jabiru 3300 Engine Sensor Alarm Upper / Lower Parameters for the D180 EMS already been provided on the Dynon site somewhere, for the - EGT/CHT/Carb Ice/ Oil - Temp & Pressure etc.. As with the rotex data that is already supplied? If so, could I get a direction as to their location, and if not, has someone out there already configured theirs and is perhaps willing to share the data?

Regards

Graham

 

[dynonsupport]

The Rotax engine was treated as a special case as there are some limits that have conditional behaviors that can not be programmed by the end user using the normal red/yellow line settings. (such as a redline that increases as the oil comes up to temperature). Note that even the Rotax configuration only sets a few limited number of parameters - it's always remains the customer's responsibility to ensure that all other caution and alarm values are set at the appropriate places. The primary source for this information should be your engine manual/manufacturer.