Knob-Panel not detected with SW version 14.0

[p.vettel@gmx.de]

Hi All,

Yesterday I changed the Software from 13.03 to 14.0. Recently (last weekend) I added 2 AP servos and the knob panel to my system. Works fine with SW 13.03. Now Skyview is not able to detect the knob panel.
Any ideas?
Regards, Patrick

 

[dynonsupport]

Patrick,
What does it say in the NETWORK STATUS page? Does it say the knob panel is missing (red) or out of date (yellow)?

 

[p.vettel@gmx.de]

It wasn't even listed in the status page. Got it fixed via a power cycle of my Skyview system with an unplugged knob panel network cable getting the unavoidable error messages. After I plugged in my knob panel and powered on again, it was recognized. So far so good.
Thanks for your reply.
Regards, Patrick