jaccoulin13
New Member
Hello, because having troubles with my D180 wired on alternator, I wired today my dynon on a magnetic sensor. But it doesn't get. Has some one a schema about wiring this sensor?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
magnetic tachometer sensor
- Thread starter jaccoulin13
- Start date
- Joined
- Mar 23, 2005
- Messages
- 13,226
I'm not quite understanding the question, but all of our installation manuals, with full connection details, can be found at http://docs.dynonavionics.com
jaccoulin13
New Member
thank's for answering.
I wired my dynon on alternator wire, but, because of bad signal, dynon indicates false values when rpm get high, with red background on numbers. So I tried to install a magnetic captor, but Dynon don't indicates anything. I'm not sure about my cableway, so that is my question..
I wired my dynon on alternator wire, but, because of bad signal, dynon indicates false values when rpm get high, with red background on numbers. So I tried to install a magnetic captor, but Dynon don't indicates anything. I'm not sure about my cableway, so that is my question..
- Joined
- Mar 23, 2005
- Messages
- 13,226
What kind of engine is this?
jakej
Well-Known Member
thank's for answering.
I wired my dynon on alternator wire, but, because of bad signal, dynon indicates false values when rpm get high, with red background on numbers. So I tried to install a magnetic captor, but Dynon don't indicates anything. I'm not sure about my cableway, so that is my question..
If this is a 2200 or 3300 Jabiru engine then try a 50kOhm resistor & increase as necessary to get desired result but no more than 100kOhm is needed.
Jake J