dynamicwt9
New Member
- Joined
- Mar 19, 2010
- Messages
- 2
Hello
I have just installed a D 120 in my aircraft, all exept the fact that the premade viering were little worong. And getting the fuel meters working were little extra job to get it working.
Only remaining problem now is that the mainfold pressure are showing wrong value. If no vacum connected with QNH 29,00 it shows some 20,5 or so.
Is there some softvare setting to cahange other than selection of sensor 1 or 2? It would be nice if there were some possibility to calibrate different sensors in the software.
This possibility would be nice for all sensors, as i can se all EGT oil temp and other temperatures are showing some degree different than room temperature. and it would be nice to have possibility to fine tune this at least to show same value at room temperature.
But my biggest problem right now is as i said to get the mainfold pressure to correct reading. :-[
I have just installed a D 120 in my aircraft, all exept the fact that the premade viering were little worong. And getting the fuel meters working were little extra job to get it working.
Only remaining problem now is that the mainfold pressure are showing wrong value. If no vacum connected with QNH 29,00 it shows some 20,5 or so.
Is there some softvare setting to cahange other than selection of sensor 1 or 2? It would be nice if there were some possibility to calibrate different sensors in the software.
This possibility would be nice for all sensors, as i can se all EGT oil temp and other temperatures are showing some degree different than room temperature. and it would be nice to have possibility to fine tune this at least to show same value at room temperature.
But my biggest problem right now is as i said to get the mainfold pressure to correct reading. :-[