Minor Bug Report-- Baro Setting & VSI

[vlittle]

I have found that if I set my Baro on the ground and leave the menu page in place, the VSI bar does not work.

I need to exit the setting page then everything works fine.

If I set the Baro in flight later on, eveything works fine.

Let me know if you need more information. Current software loaded, D10A.

Vern

 

[dynonsupport]

Nice one. To workaround this while we get the fix in the firmware: wait 30 seconds for the Altitude bar to come up before adjusting baro. Then the VSI will stay up even with the menu up.

 

[vlittle]

Not sure waiting for the Altitude bar fixes the problem. I don't adjust baro setting until after I get the ATIS, by which time the unit is stable. My work around is just to exit the Baro setting page after adjustment. Any rate, it's not a big problem.

It was only a problem during formation take-off when I had to climb at airspeed and vertical rate. I noticed that the VSI bar wasn't showing.

Vern