Missing "APT->COM" or "TUNE COM" selections

[RodDavis]

I have seen it in the user manual, but I have not seen a "APT->COM" or "TUNE COM" selections on the "APT" or "FREQ" tabs within the airport information page.  I have the latest Skyview software updates, good GPS signal and the NRST function on the SV-COM-C25 com panel works as expected.  Any suggestions of what I'm (probably obviously) missing?

 

[dynonsupport]

Check SETUP MENU > SYSTEM SETUP > PRIMARY COM. If your SV-COM-PANEL isn't shown there, update that setting. Then those tabs will work. (Without that setting being correct, SkyView doesn't know where to "send" the data.)

I have seen it in the user manual, but I have not seen a "APT->COM" or "TUNE COM" selections on the "APT" or "FREQ" tabs within the airport information page.  I have the latest Skyview software updates, good GPS signal and the NRST function on the SV-COM-C25 com panel works as expected.  Any suggestions of what I'm (probably obviously) missing?

 

[RodDavis]

Yes, this was absolutely it... works as advertised.  Thanks.