Hello,
I have installed a D100, D120 and RV9 roll servo. When I have applied power, I couldn't have a DSAB connectivity. I have noticed that when I pulled the servo circuit breaker, I could recover the DSAB. So I have disconnected the DSAB pair going to the servo, and the DSAB was fine. I have upgraded the D100 and D120 to firmware 5.4, everything works fine, included the D100 associated magnetometer and OAT. Then I have inverted the two DSAB leads going to the servo, applied power again, and the DSAB stays up. But no servo in sight on the network. As the bus was fine when the servo breaker was pulled, I can assume the servo is being powered and the data twisted pair is reaching the servo.
Thanks in advance to Dynon Support
I have installed a D100, D120 and RV9 roll servo. When I have applied power, I couldn't have a DSAB connectivity. I have noticed that when I pulled the servo circuit breaker, I could recover the DSAB. So I have disconnected the DSAB pair going to the servo, and the DSAB was fine. I have upgraded the D100 and D120 to firmware 5.4, everything works fine, included the D100 associated magnetometer and OAT. Then I have inverted the two DSAB leads going to the servo, applied power again, and the DSAB stays up. But no servo in sight on the network. As the bus was fine when the servo breaker was pulled, I can assume the servo is being powered and the data twisted pair is reaching the servo.
Thanks in advance to Dynon Support