OAT wiring on a D180

[jaccoulin13]

Hello,
I wired my OAT on D'37 on pin 4 and 16 (GP1). I tested wiring without problem, but I don't have any T° on my screen. OAT is moving around 7 Kohms. Is it a problem of setting?

 

[jakej]

More than likely - just recheck/change settings, that won't hurt it.

Jake J

 

[jaccoulin13]

Well, I did it 2 or 3 times, selecting OAT 1, OAT 2, changing my wires on GP2,...
I think I make something wrong, but I don't know what...

 

[jakej]

If this is a 2 wire probe then the pins you used are correct.

Did you tell the D180 "Y" (yes) for OAT installed ? Refer to pages 9-8 & 9-9 of the install manual (Revision G).

HTH

Jake J

 

[dynonsupport]

If you've got it hooked to a GP input you have to set EMS>SETUP>SENSORS>[the correct GP input] to OAT. The EFIS>SETUP>OAT should be set to N.

 

[jaccoulin13]

Ok, thank's. I will try this we.
Maybe should it be written on manual?

 

[jakej]

Geez, don't you guys read the manual ? it's there, page 6-17, plain as daylight. : It's fair enough to ask a question but a SIMPLE issue like this could have been resolved by reading the manual first - most of us want and like to help but you've got to try and work it out too.

Jake J

 

[jaccoulin13]

Well, it's ok now.
I'm a french guy, so I don't read easily technical english books. I readed notice a lot of time, but I did'nt understand that I have to set General Purpose. I just tried to configure by EFIS OAT setting..

Sorry, and thank's for help