One time only, after pressing <level>, 1 of 2 servos did not engage.

RandomSquawk

Member
Joined
Jul 17, 2020
Messages
30
While waiting for the engine to warm up I often press <level> to check that servos engage, and that I can override (slip) them. Recently the pitch servo engaged, but the roll servo did not. After 10 or 15 seconds trying to prove I wasn't losing my mind, I pressed <disengage>, followed again by <level>. At that point both servos engaged as normal. I did not see or hear any messages, and it never did that again (so far).

Where, in the data, might I find evidence of this event? I know approximately "when", and I export logs to my laptop every day.
What might cause this behavior?

HDX in 2019 Rv-12 ULS stock configuration.

Chris
 
Top