Re: Garmin GNS430 - SV interface No Labels

[dynonsupport]

First off, you must be running SkyView software 10 or newer for this feature to work.

This behavior will occur if you don't have the RS-232 serial out wire connected to the ARINC module correctly, or if you have the 430's serial port mis-configured, so I would start there.

 

[skypilotusa]

Thanks Dynon... I checked with my Avionics shop and conpared the harness documentation, they had the RS232 as pin 59 on the GNS430. The shop said it should read as pin 58. (Typo)

I went into setup and it was set to chnl 1 (59)... I switched it to Chnl 2 - Aviation, which would coincide with pin 58... everything works great now... Thanks again.