jacktunnell
I love flying!
- Joined
- Jan 19, 2013
- Messages
- 41
My Skyview is not even recognizing my installed and previously working servos. I don't get any Auto-Pilot legends above the buttons on the SV.
I have no Transponder or Auto-Pilot warnings.
My transponder firmware is on-line HW22.03 FW01.02 SW02.09.
I'm getting .02 amp readings for the servos on my VPX Pro.
The servos are on the same SV net as the ADAHARS and they are working fine.
I'm on my SV-ADAHRS-200.
I'm thinking this must be configuration but I'm lost on what to check next.
I have no Transponder or Auto-Pilot warnings.
My transponder firmware is on-line HW22.03 FW01.02 SW02.09.
I'm getting .02 amp readings for the servos on my VPX Pro.
The servos are on the same SV net as the ADAHARS and they are working fine.
I'm on my SV-ADAHRS-200.
I'm thinking this must be configuration but I'm lost on what to check next.