Hello, just did my first engine start (yea) and I had double the RPM I should have. I assume there is a setting or something I needed to adjust. Then I read the manual again...so I am still not sure...is there a setting to adjust or do I need to add the resistors. I am running IO 360 AIA, with dual p mags. thanks.
RPM double
- Thread starter rlallen1
- Start date
mmarien
Murray M.
You can set Skyview - in the hardware calibration I think, or you can set the P-Mags to one or two pulses. You don't need the resistors.
- Joined
- Mar 23, 2005
- Messages
- 13,226
Page 7-28 of the install guide, very top.
If you have double the RPM you should, you need to double your pulses per revolution setting.
If you have double the RPM you should, you need to double your pulses per revolution setting.