Bubblehead
Member
- Joined
- Oct 3, 2011
- Messages
- 37
I have a pre-2006 RV-8 into which I am installing a 10" Skyview along with pitch and roll servos. The Dynon supplied brackets seem to be 3/8" short. When I line up the holes where the bolt goes through the brackets and the bellcrank the non-tapered end is shorter than stock one and that leaves the last rivet close to the end of the new bracket.
Has anyone else run into this? I have attached a picture.
Has anyone else run into this? I have attached a picture.