Servo stuck in TST after calibration. HELP!

[Bruce_Russell]

I just finished installing two servos in my RV-12 with AP 74. After teh calibration and test procedure the AP status on the D180 shows -TST-TST for the servo status. What do I do to fix this?
Bruce

 

[dynonsupport]

This implies that the test procedure didn't fully complete. One thing that causes this is if the disconnect switch is permanently grounded.

 

[jakej]

Check the disconnect switch ... there has been a case of someone inadvertently using a NC switch as opposed to a NO type also do you have the resistor fitted ?

Jake J