SkyView A/P disconnect wiring

[n223rv]

I'm mid-stream in wiring up my SkyView and couldn't seem to find the autopilot disconnect on the wiring schematic/pin out tables. I was hoping to have an A/P disconnect switch on the stick. Is this a feature, and if so, what pins do I use? Thanks
-Mike

 

[schristo]

the a/p disconnects on a ground signal to either of the servos on the yellow line... the dynon wiring diagram shows a common signal to both wired to a switch to ground to disconnect located wherever you want...

http://www.dynonavionics.com/downloads/SkyView%20Servo%20Connection%20Diagram%2005Jan2010.pdf

 

[dynonsupport]

Correct - the servos get the disconnect directly. There is no disconnect at the screen.