Skyview configuration problems

[jhsalden]

Hello Dynon,

I have installed a new Skyview. But I have some problems:

1. Remote battery is connected. Skyview works w.o. aircraft power but remote battery is not detected.
2. Same for OAT and GPS antenna.
3. Callibration compass goes not further than North. If you go to east it jumps back to north.

Network calibration was done several times.

Who can help?

Joost

 

[llacy]

I have the same problem calibrating the compass. The indication stays on north and when I press acquire it counts down to 100% but nothing happens. The heading stays the same 332 degrees and won't go to the other cardinal headings
Lou Lacy

 

[dynonsupport]

You do have to point the aircraft precisely in each of the cardinal directions to calibrate the heading correctly. I'm wondering if you're just trying to acquire all four directions while still.

When you say that the battery, OAT, and GPS antenna, where do you mean? They're not SkyView network devices, so they wouldn't show up there. (Battery status is in SETUP>LOCAL SCREEN SETUP>SCREEN HARDWARE INFORMATION though)