olegburlacu
I love flying!
- Joined
- May 3, 2016
- Messages
- 3
Hello,
I have a 2 x Skyview Touch setup with Powerflarm Core connected to Serial 3 (configured as FLARM TRAFFIC, with baudrate of 19200).
On the displays I have "FLARM OK", in Serial setup I have only "Good sentences", but no targets are shown on map.
Last 3.5 years it worked OK. How can I debug this?
I'm using latest 15.4.7 software. Can be software version related?
I have a 2 x Skyview Touch setup with Powerflarm Core connected to Serial 3 (configured as FLARM TRAFFIC, with baudrate of 19200).
On the displays I have "FLARM OK", in Serial setup I have only "Good sentences", but no targets are shown on map.
Last 3.5 years it worked OK. How can I debug this?
I'm using latest 15.4.7 software. Can be software version related?