The RV8 Pilot
www.rv8-hangar.com
- Joined
- Nov 1, 2015
- Messages
- 24
Ok I just drilled and installed a 3.5mm music jack and ran the 3 conductor shielded wire to the area where my intercom will be along with all the other wires for the intercom. I was just looking at my work and it came to me: do I need to isolate the 3.5mm jack from the metal structure like I did with the headphone/mic jacks? I didn't even think of this until admiring my work and looking at the headphone/mic jacks that are near the new music jack. If required any advice on how to do it, I didn't see any isolation washers this size? This is the jack that will connect to SV-INTERCOM PIN's 24,11 & 18
Thanks, Michael
Thanks, Michael
