SV reboots non stop after xponder update

[godob]

This is a new installation on an RV12. I´ve updated de system to v. 5.1 and detected the different modules using Network Config and everything went fine.

Trying to set some transponder parameters, I was prompted to update the transponder firmware.

Since then the system reboots non-stop. I´ve even disconnected the battery and (one at a time) first the transponder, then the EMS, but problem persists.

I´ve tried to power cycle the SV by holding botton 1, but no improvement.

Now just the ADHRS and screen are connected, and problem persists.

Any ideas to get this to work? Can I go to the previous firmware somehow?

Thanks in advance

Godo

 

[Dynon]

Where in the process did things go wrong? In any case, you should call our tech support staff at 425-402-0433. Unfortunately, we'll probably need to see your display here.