Hi everyone.
My build has HDX with Ap Panel and Ray Allen electric trim.
I‘ve wired the signal from the trim to Pin 10 on the EMS 220. However when I attempt To map this I hit a roadblock.
After setting the function as “sensor”, and picking ah ohm setting, I only get a fixed choice in the “drop down” name section being either flaps, elevator, aileron or rudder. I can’t find trim anywhere in the name section of any pin.
Im stuck.
Thanks
Peter
My build has HDX with Ap Panel and Ray Allen electric trim.
I‘ve wired the signal from the trim to Pin 10 on the EMS 220. However when I attempt To map this I hit a roadblock.
After setting the function as “sensor”, and picking ah ohm setting, I only get a fixed choice in the “drop down” name section being either flaps, elevator, aileron or rudder. I can’t find trim anywhere in the name section of any pin.
Im stuck.
Thanks
Peter