ul power config

[spudlyhallam]

Has anyone started to set up a ul power with the skyview I am about to and am not sure if the k type cht sensors will work.
Any one out there want to share info?

 

[jakej]

Reading the install manual would be a good start

Jake J

 

[spudlyhallam]

very true but unless I have missed something dynon is set up for c type cht and the ul supplied ones are k type so there lies an issue that I need help with.
Any ideas

 

[dynonsupport]

very true but unless I have missed something dynon is set up for c type cht and the ul supplied ones are k type so there lies an issue that I need help with.
Any ideas

spudlyhallam:

Dynon's SV-EMS-220 has 14 inputs that can be configured for Type J (CHT) or Type K (EGT) thermocouples. The SV-EMS-220 doesn't support Type C thermocouples.

 

[spudlyhallam]

Hi thanks for the answer shame I was a bit dull and typed C instead of J type
So does anyone know if i can use the Ktype CHT ones or do I have to buy J type?

 

[dynonsupport]

You can use J or K types for CHT on SkyView. You just choose it in the setup menu. With a little work you could even use C type CHT (if your CHTs were 2000C in a pure vaccum!)