Have any of you who have the SV series upgraded from a D180 to the SV series? I am looking for the changes in wiring needed to have the plug and play harnesses be correct for the SV EMS. I know that I have to reroute the OAT from GP1 on the D-180 to the SV ADAHARS and apply voltage to pin 1 of the 37 pin connector to the D-180 so the SV will have a voltage reading. Anyone else who have been thru this process have any further tips? There is nothing in the install manual about ujpgrading just initial installs. I confirmed this with Dynon Support. Thanks for any heads up, Dan
Upgrading from a D-180 and D-100 to SV-1000
- Thread starter 65xx
- Start date