Latest activity

I'm going to have Six Pack Aero replace the factory original control yokes with new ones from Cessna. The new Cessna yokes are a better...

No voltage suggests in installation error. Low voltage spread is fine, even with the warning, as long as it is consistent.

Connect your FLAPS position signal to the VP-X Pro (J1 Pin 17). The TRIM position signals depends if you are installing a SV_AP_Panel...

Please be very specific here - NO VOLTAGE shown, or it gave you an error saying the voltage didn't change enough to be usable? Two very...

You're welcome.

EGT as an absolute value means nothing. Each probe is going to end up in a slightly different position, different distance from the...

EGT as an absolute value means nothing. Each probe is going to end up in a slightly different position, different distance from the...

Hello all, What about Van's capacitance plates? I installed them on both reservoirs, and installed Dynon capacitance converters, bus...

Be aware that sometimes Dynon inverts EGT and CHT probe labels...check wires colors instead:D That was the issue....

I am wiring my flaps and trim now. Should I run the position signal through my Dynon HDX or my VP-X Pro? I noticed Dynon has only one...

I have two EGT probes. Since installation they have never been balanced (the same). Checked everything, decided is just the probe...

Mine was a poor electrical connection where the thermocouple wire connects to EMS wire.

I am having same problems on one CHT probe. Temps All over the place. CHT is consistent. Gunna switch out sensor probe soon. I know it's...

I have one egt probe that is all over the place. CHT temps are consistent.. It's obvious that probe is going south. I'm sure yours is...

Thanks. I was afraid I was right. Maybe there’s a way to design a diy input management system (for non-critical items) that can talk on...