Latest activity

Just test flew a Glasair 1RG with a Dynon classic. After boot up the airspeed shows 0 knots. As soon as I started the engine at 700...

Is it selected as a MAP LAYER in MAP CONTROLS? It won't display otherwise.

What are you seeing for amperage when this occurs? Check all your cables. Make sure they are well seated. Pins 1 & 2 on your EMS...

Begin with your schematic... and checking that connectors are secure and tight to your EMS module, I assume an SV-EMS-220. Bus voltage...

Scope this cool project out... an airplane quilt! The backside has minkie on it, so it's incredibly soft and warm. This quilt pattern...

Scope this cool project out... an airplane quilt! The backside has minkie on it, so it's incredibly soft and warm. This quilt pattern...

Now using HDX with SV-EMS

Been using my HDX with EMS for a while. The bus voltage now suddenly shows Zero. Everything else is normal. Battery is fully charged...

Need more specifics. I would start by downloading the EMS data log. You can then review the Excel file for correlations and anomalies...

Could be a bad probe, a bad connection or a problem in the EMS. Check the spade connection crimps. If still reading incorrectly, swap...

Someone with two legacy D1000 screens asked my advice. The Jeppesen Aviation and Obstacle data base shows installed but there is...

During a test flight yday my No 3 EGT temp went off the scale (1111 deg C) & stayed there even when the engine cooled down after...

How much to send to Canada Garson Manitoba R0E 0R0

Yes, who knows, but it’s been perfect since I added the second feeder. Flew 45 minutes out and again back, it is working perfect.

I reinstalled the nav data base and all is good. Thanks for the help.