Latest activity

New installation. How do I swap my fuel level indicators? The right tank is on the left and vice versa. Thanks, AR

Update: I rebooted the HDX with the thumb drive in the USB. Several messages flashed on the screen followed by the PFD. So I think...

I completed a new HDX installation and am updating the software. My last screen says Firmware Update 100% and it is frozen now for 30...

Yes, that would be prudent, thank you for the suggestion. For now, no immediate or close-by candidates available to test my A/P PANEL in...

Were the headset jacks removed? Do you have shoulder and fiber washers installed on the headset jacks?

Is the vinyl wrap preventing the panel grounding to the airframe? Perhaps the bare aluminium was grounded to the airframe but, now it's...

Quite a few forum threads and articles have at various times addressed ground loops, and their potential to cause noise or other...

Have you reviewed this? https://forum.flydynon.com/threads/ground-loops-and-noise-in-aircraft-systems.14716/

The weird part about that is, the panel was bare aluminum before, and it was working perfectly for almost 2 years. Add some insulating...

I’m no expert but I would certainly try isolating your equipment from the panel, as it sounds like you’re getting a ground loop by...

I had the whole instrument panel pretty much done, everything worked. Then I wrapped it. I pulled everything out of the front that...

FWIW I’d do is try your a/p panel in another plane - NOT a ‘loaner’ in your 8. If there is a problem in your 8 other than the a/p panel...

There's a reason they make covers for pitot tubes...

Thank you for the heads-up about this issue. I'll keep the panel area free of any stainless steel coffee mugs!

Caution with the copper bus bars, make sure they are covered with something during install, or inaccessible from your seat. I ruined a...