Latest activity

OK. Yours might be slightly different as will depend on what you already have configured… SERIAL IN DEVICE: Garmin 296. (Others will...

I agree. It's patching in all the other stuff he wants that will be his biggest challenge. I knew what you were getting at. But you...

My point was, with a $40 switch and a couple of ethernet cables, the OP can have what he wants. Seems simple enough.

I had something similar happen with no real solution, but to say you are not alone. My hardware version 1 HDX1100 died so I installed a...

I did. As Rhino suggested, I asked Dynon directly and got this answer: I'm going to run some prints with theirs and the EASA/Airbus...

A crossover cable has pins reversed from a standard ethernet cable, so they are not interchangeable. Dynon uses a crossover cable...

Had this issue with my friends' RV-12. The secondary network cable pinouts were backwards. The white with blue stripe, and the white...

So I don't know crap about having a 3rd display - I only have two. But you already know what you need to do for the SV-NET and for all...

Just visually. It would be nice if there was a loopback test from the primary network to the secondary network on the DB-9 connector to...

Then you'd just use an unmanaged hub or switch with standard cables, and ditch the crossover. I don't have the diagram for the rest...

I understand the SV-NET-HUB connection - and that is not an issue. However the two existing displays are connected via Ethernet also -...

I'm not sure what you mean by "network hub for ethernet etc." The SV-NET-HUB is serial. You can't combine it with ethernet. Adding a...

Yes.

I have an RV-12 with a Rotax 912 ULS engine. It's my understanding that the HDX has a Totalizer in it. The RV-12 has a fuel return line...

Thanks Jake, I'm confident I'll manage. If lost, I'll come back to you. I ordered a trim relay and it has a pretty straightforward...