Latest activity

Your unit is probably the later unit so modifying/replacing it will not change anything if it's an earlier unit in which case a cheaper...

Just so that I can calibrate, do I actually have to: Bail out of a burning airplane TELL you that I bailed out of a burning airplane...

I was going to reply something along the lines of RTFM - but Kevin Eldridge? Nahhh, I'll cut him some slack, I watched him bail out of a...

Contact Dynon with the serial number of your EMS, they may have a fix for that. The phone call is free. :cool:

I'll ignore the obvious drawbacks you've already mentioned. A ground on P22 will do nothing except 'activate' that input to an always on...

I would like to verify whether the following conditions could possibly harm a Skyview Classic EMS-200 unit and/or devices attached...

Great - I'll take a look at this too. Thanks.

Yes, I've seen an installation where on transmit, all the CHT and EGT's go high. In this case, it was because the VHF antenna coax...

Thanks for this. I'll check the items you've mentioned. Appreciated.

I’d be checking the connectors especially if they’re the type where the shield is held in place with a nut. Also check the centre pin is...

What I do is just select any 5amp circuit & then label it as Garmin 175 & allocate it to an avionics switch (you can have many other...

I have a SV/HDX system in my RV-7A and am installing a GPS 175. The GPS 175 installation manual says the GPS 175 can't share a circuit...

Could you send the TSO version of the IM? I have the AML. jgbehu@gmail.com. thanks

I assume you mean that you've got a System32 EFII from FlyEFII (that's what the pics look like on your web page). Per the FlyEFII...

Thanks. Definitely the system is not pulling that much power. It seems to be a spurious issue and the stray RF idea seems very plausible.