Latest activity

Hello everyone, I have been flying for over 10 years with a D10A and an SV32 servo for roll. During installation and testing, I had no...

After a couple of months the little airplane on the screen shows up angled off the direction of travel and the indicated wind direction...

What do you mean by loses it's calibration?

@Blimpguy Hi David, Is it possible to revert an update if a previous version showed the transponder as working properly but the new...

Hi Jeff, If you haven't already, please email us at support@dynon.com. You can put attn: David and it will get to me directly.

I have been successful in calibrating my Skyview compass (both on the ground and in the air) but after a few months it seems to loose...

No success with my newish HDX. I waited 10 mis after it hung up at 99% complete. Pressed buttons 1,2 and 5 all together , rebooted and...

Great. Glad you got it worked out.

Not that hard, actually. Go into Setup menu, EMS Setup, Sensor input mapping, select Fuel Level, and pick or write your own. Easy peasy...

Not that hard, actually. Go into Setup menu, EMS Setup, Sensor input mapping, select Fuel Level, and pick or write your own. Easy peasy...

The GPS-175 obviously has to use the ARINC-429 to connect to the HDX, and the GNC-215 does conform to the SL-30 protocol, so it likely...

these are the steps aI've done andthe result: Steps performed: Updated both HDX displays to SkyView v17.3 (both powered on, aircraft...