Latest activity

You don't necessarily need one. Pins 1 and 20 on the HDX provide power for a dimmer knob, so you don't need a fuse if you use that as...

I am going to repurpose a baggage light dimmer switch (0 to 12 volts variability) to control the brightness of the Skyview display, as I...

My original post was to express my frustration of waiting over 5 years with zero news about possible certification for my "type"...

THANKS SO MUCH FOR THE SUGGESTION! I GOT TO THAT PAGE BUT COULDN'T GET IT TO TAKE IT. I WAS DOING IT WRONG.... BRAD

Always connect to the EIS/EMS grounds - you can pair up the grounds if there are not enough individual grounds available - that...

Thank you, the table is helpful as well!

Yes, I have done that and verified my registration number correct as to O or 0 (zero). Not sure what else to do at this point. Thanks...

Yes. https://www.dynonavionics.com/includes/guides/SV-HARNESS-INT_Harness_Guide-Rev_A.pdf

Here's my panel with the AP installed. Follow the instructions and all went as advertised. Do not install a switch to turn off the yaw...

I’m in the process of upgrading my radio/intercom to match my skyview system. I’m not sure if the shields are already grounded but it...

Have you gone into Setup > Traffic Setup Menu and set the Show Ghost Targets option to NO? (see attached) Andre'

Here's my panel with the AP installed. Follow the instructions and all went as advertised. Do not install a switch to turn off the yaw...

To Dynon Support, do you have any update to this HDX reset? Thanks

Hi there, If you use this link to submit the files to us, someone will be able to review them to see what caused the reset...

Same happened to me (Skyview Touch) poking at a map item for info. I have a diagnostic zip but the page above shows no upload facility.