Latest activity

Folks, Thanks for the advice. Dynon advise me that the Connector Kit is Molex P.No SKU-MM3-2PIN, which uses a P.No 43031-0001 Crimp...

Have you discussed this with Dynon? You make no mention of it in you post. They do not monitor this forum continuously so you should...

Mine does the same, always has. My exhaust & cowl are evidently tight enough to keep the carb hot at ground idle. Being bolted to a...

Thanks for the reply, I did find out how to look at the split screen output from each ADAHR while flying. I tried it yesterday but the...

FYI...going to try a friends Skyviews Brightness settings first...his works fine in the dark and is visible using the following settings...

Have you discussed this with Dynon? You make no mention of it in you post. They do not monitor this forum continuously so you should...

Thank you!

I have a SV-T Classic, not HDX, but it should be the same process. To you first paragraph, just do the monthly update, then as you...

Mine does the same, always has. My exhaust & cowl are evidently tight enough to keep the carb hot at ground idle. Being bolted to a...

Hi Knut, I have an O360 with a carburetor air temperature sensor. During startup and taxi the Carb Temperature will always read much...

Have you discussed this with Dynon? You make no mention of it in you post. They do not monitor this forum continuously so you should...

My WiFi isn't working properly too, iPad HDX. I've tried everything possible, even with just one Dongle, but without success. I think...

I have a different ammeter shunt than the one supplied by Dynon, so I need to edit my Sensor Config File to change the c_X1 constant. I...

On the last few flights my attitude indicator goes up to very high angle of attack (up to 45 deg), the skid ball goes from left to right...

Hi Vlittle, thanks for replying, AP only turns off when Camera is displayed. No Harware issue! Mike