Latest activity
-
RRV7Builder replied to the thread Using EMS input 23 ( General Input Type C) for detection of Fuel Pump Running.Hi thank You very, much ! I need a Digital Value "Pump ON" when i have 12 V on the Pump Power source., so i think Pin23 should be fine...
-
SPersonally, if it’s a nylon fitting like you are using, I would not use anything as the soft nylon should fill the gaps and provide a...
-
SSkippyDiesel reacted to andresmith76's post in the thread Compass Calibration: Looking for Alternate Method with
Like.
Lon - To answer your question - no, you cannot offset the Dynon as you described. I recently calibrated my ADAHRS unit and used the... -
SSkippyDiesel replied to the thread Aoa failure."Definitely no blockage ...." Are you sure ?- use compressed air (with care) to blow clear. ".....no leaks." Again - Are you sure? If...
-
CCanardMulti replied to the thread Fuel Calibration.One item NOT in the manual: be patient. Give the voltage numbers on the screen plenty of time to settle down completely before saving...
-
Rhino replied to the thread Using EMS input 23 ( General Input Type C) for detection of Fuel Pump Running.Unless your voltage can spike over 30 volts, and I don't see how it could, it shouldn't be needed. It's rated to handle spikes that... -
RRV7Builder posted the thread Using EMS input 23 ( General Input Type C) for detection of Fuel Pump Running in Installing SkyView.Hi, i woul like to have an indicator in my HDX when the fuel pump is switched on. For this i have a free signal input on my EMS. PIn 23...
-
JUpdate, found the problem: After removing the empennage fairing and cross-referencing my January 2019 build log photos with the Dynon SV...
-
Bbenapilot replied to the thread Fuel Calibration.Good stuff! I temporarily installed the HDX today and started the fuel calibration process to get a look at what I’ll need. On my 39.5...
-
Ggreentips replied to the thread Fuel Calibration.Good points. I did not deflate the nose wheel or strut. I did level the airplane r/l and set the fuel selector to the opposite tank to...
-
Update, found the problem: After removing the empennage fairing and cross-referencing my January 2019 build log photos with the Dynon SV...
-
Rr2brou2 replied to the thread Fuel Calibration.I think you tell it the max fuel quantity and it tells you how many gallons to put in with the last one saying fill the rest of the way...
-
JAfter fixing some wiring issues that had my autopilot down, things work great when I set altitude and heading from the AP74. Here's my...
-
Update, found the problem: After removing the empennage fairing and cross-referencing my January 2019 build log photos with the Dynon SV... -
Ggreentips replied to the thread Fuel Calibration.I have the old stewart-warner style resistive gauges. I followed the dynon procedure for that. I think the calibration for those...