Latest activity

I confirmed yesterday that if i enter a flight plan into skyview and change the HSI source to Skyview the next waypoint identifier is...

I confirmed yesterday that if i enter a flight plan into skyview and change the HSI source to Skyview the next waypoint identifier is...

Last I heard, it doesn't interface with STEC products. But someone please correct me if I'm wrong.

If the D10A can connect to the STEC-55X, how does it connect? Through the RS-232 lines?

Sure can. You can edit the location of the widgets as below. It is in the installation manual

And also, know that you should be able to restart a display by pressing buttons 1/2/5 at the same time.

Just for point of reference (in case someone stumbles across this thread wondering what USB thumb drive to buy), I've been using the...

Exactly correct, I had to do that once, just call them and they'll give you a code.

I’d just contact Dynon Support with the ‘old’ & new display serial numbers & they’ll give you a new code - easy peasy.

I’d just contact Dynon Support with the ‘old’ & new display serial numbers & they’ll give you a new code - easy peasy.

When this happened with me (on the most recent update), I removed power and then turned it back on and the update continued to load. All...

I’d just contact Dynon Support with the ‘old’ & new display serial numbers & they’ll give you a new code - easy peasy.

OK, that problem is fixed. Thanks for the responses. I have a call in for Tech Support. Sounds like they're busy. Next problem is...

This same scenario has also happened to me. I did what wilersk did and after the reboot, all systems were once again normal and the...

This same scenario has also happened to me. I did what wilersk did and after the reboot, all systems were once again normal and the...