Latest activity

What jnmeade said & further elaborating my post #8 - check the pins at the ends of the coax BNC fittings. The pointy end of the pins...

I have it on mine, but I don't remember how I did it and I'll try to look into in a day or so.

Well, I have observed similar conditions on my Dual HDX with Dual Dynon Backup Batteries. Secondary system standby bus backup battery...

Not sure if the failure was on receive or transmit. While flying we just discovered we had no radio. I’m waiting for an answer from...

I have been trying to get a combined CHT/EGT graph displayed across the bottom of the display. I can't figure out how to do this. Does...

My guess is that if the radio died while you keyed the mike, the likely culprit is the antenna circuit, no matter what the VSWR is at...

Hi Gregg - you can DM me if you like. Given the number of 760 units ‘out there’, & possibly no similar reports, I figure 3 in a row for...

Hi Gregg - you can DM me if you like. Given the number of 760 units ‘out there’, & possibly no similar reports, I figure 3 in a row for...

Hey Jake, Thank you for the reply. Yesterday I disconnected the radio, the comm head and the intercom. I pulled out the prints and...

I'm using the proportional current output on pin 5 of the Molex connector, and you're correct, those polynomials made little sense. I've...

So now we know the ‘fault’ is not a radio failure but a wiring/airframe issue - very sorry to be so blunt however you really need to...

Are you using the hall effect output from the Monkworkz or a shunt? Where did you get those polynomial numbers? If using the...

Bardample, Can you share your settings config file for the Monkworkz current, presuming you are using the output from the Monkworkz...

Rotax 912ULS. No mixture control for leaning on the Rotax 912ULS. I thought it might be related to the temperatures for the ranges...

What engine do you have? If it's a Lycoming or Continental, I can't help but wonder if this has something to do with lean of peak readings.