Latest activity

No, I meant were you aware it has a separate volume setting in the audio menu? That's probably what you were referring to when you said...

Yes. It's so small and I can't hear the beeps. My stall horn is more useful.

Just out of curiosity.... https://forum.flydynon.com/threads/small-size-of-aoa.15395/#post-90289

Is there a way to turn up the volume on the AOA beeping. Its 100%. Sounds fine on the ground with no engine running. In the air it's...

My AOA volume is 100 in dynon setup, then best controlled on AUX 2 through GTR200 radio

bump

The Dynon OAT is a solid state thermistor, with no moving parts, whose service life will most likely match that of the aircraft...

The Dynon OAT is a solid state thermistor, with no moving parts, whose service life will most likely match that of the aircraft...

The Dynon OAT is a solid state thermistor, with no moving parts, whose service life will most likely match that of the aircraft...

Sorry: Skyview, Dynon OAT, located very far from the ADHRs. Ran my own 20 ga wires from the ADHRs to the OAT. An old USN Chief who...

What Glenn said. Install using the Dynon provided connector and don't look back. Highly unlikely it will ever need to come out again.

You didn't mention if it was Skyview or not. With the OAT probe supplied for the ADAHRS unit, it has the connector not installed, just...

I'm using molex microfit connectors (like on the backup battery connectors) in my system, but even a 2 wire connector is too big to fit...

You either did not configure the SkyView audio out properly, or you have a hardware problem. Are you feeding the SkyVIew audio out to...

Yes, a PS Engineering audio panel. You could however use separate switches for mic and audio control. Carl