Latest activity

I'm about ready to install my manifold pressure sensor and expected part # 100434, which has been discontinued. I received part #...

Never mind, I think I found it... On page 12-10 of the Skyview Installation manual (Rev AJ), last two-line paragraph, it says: I'm not...

Thanks for the input. I did install it today using one of the GP Pins and set it to the Dynon OAT sensor as a test and the sensor is...

Then it should be fine with a general purpuse EMS input channel. I have dome similar with a PTC, the hard part might be just finding...

Actually there’s a lot of books, c ya later alligator 🤣 it’s still the English language like u speak, just a little different - well, a...

I was getting ADS-B Partial sometimes here in northern Ohio. It also seems to be reported as ADS-B No Radar. From the user guide: An...

Then it should be fine with a general purpuse EMS input channel. I have dome similar with a PTC, the hard part might be just finding...

It is a thermistor style which is the same at the Dynon OAT…

Note that thermocouples generate a very small voltage (mVolts) and thermistors are a variable resistance, so these two need very...

Note that thermocouples generate a very small voltage (mVolts) and thermistors are a variable resistance, so these two need very...

https://forum.flydynon.com/threads/k-type-carb-air-temp-thermocouple.15065/ If it's a thermocouple, it should work. Thermistor might as...

I don't know if the grill sensor would work, but the below if from the manual. It can't hurt to hook it up to the general purpose temp...

https://forum.flydynon.com/threads/k-type-carb-air-temp-thermocouple.15065/ If it's a thermocouple, it should work. Thermistor might as...

I don't know if the grill sensor would work, but the below if from the manual. It can't hurt to hook it up to the general purpose temp...

I am considering adding a generic Air Temp sensor inside the engine compartment on my Experimental Aircraft. I have a two wire sensor...