Latest activity

  • J
    jakej replied to the thread Failure after software update.
    Ok, unless you’ve removed the backshells & THEN did a gentle pull test on the wires, you’ll never know if the old cable was the issue...
  • S
    sstearns2 replied to the thread Failure after software update.
    I did a continuity check on the network cable connected to the problem screen. I really had to dig around in the pin holes to make...
  • K
    kiprock replied to the thread Dynon ADSB.
    I also have a Stratux, which is usually rock solid. I purchased the black dongle with the antenna for my HDX system as a backup, but...
  • L
    LN-YML posted the thread Superneurone in Installing SkyView.
    I have purchased the super neurons from flyingneurons. I used the serialport 4. in the Dynon setup I have chosen the serial in device...
    • IMG_8601.jpeg
  • B
    Bob Y replied to the thread Dynon ADSB.
    The old adapters/dongles were white and the latest versions are black - either should work ok. If they’re “putting out wifi” you should...
    • IMG_3042.jpeg
    • IMG_3041.jpeg
  • D
    dbuds2 replied to the thread Dynon ADSB.
    Thanks, I did see in the documentation that it will do as you wrote. My Skyview already puts out wifi with a little usb dongle, am I...
  • cbailey
    cbailey replied to the thread Pneumatic Rivet Squeezer.
    I might be interested. Any pictures? Manufacture?
  • B
    Bob Y replied to the thread Dynon ADSB.
    The ADS-B module does not transmit a Wi-Fi signal, but if you install a Dynon Wi-Fi adapter to one of the USB ports on the back of the...
  • D
    Does the Dynon ADSB unit also broadcast wifi to a separate tablet? Today I have a Raspberry PI Stratux that look like it has gone belly...
  • mmarien
    mmarien replied to the thread Bug In EMS Display Widget?.
    I check back to my previous Skyview. Inverted arcs worked properly there.
    • screenshot-CGAFT-SN01164-15.2.0.4389-20061231-214630-167-en_US.png
  • mmarien
    mmarien replied to the thread Bug In EMS Display Widget?.
    I found the same problem. My Main fuel gauge is an inverted arc, but it's reading clockwise. Is there a fix for this?
    • screenshot-CGOJK-SN38024-17.4.0.23677-20260327-150139-108-en_US.png
  • S
    smookyfish replied to the thread Pneumatic Rivet Squeezer.
    Okay
  • D
    Danerazz replied to the thread Pneumatic Rivet Squeezer.
    I appreciate it, but I just ordered a new yoke for a manual squeezer and will make do. I probably don’t have enough rivets to squeeze...
  • S
    smookyfish replied to the thread Ap74 available.
    Thank you
  • S
    smookyfish replied to the thread Pneumatic Rivet Squeezer.
    I happen to have another if you are still interested.
Top