Latest activity

The ADSB No-Signal error, if it occurs in an area and at an altitude where you should have reception, can be caused by the receiver...

For anyone interested. $110 shipped

The ADSB No-Signal error, if it occurs in an area and at an altitude where you should have reception, can be caused by the receiver...

So I flew yesterday and the problem did go away airborne, so maybe Dynon was right in my case. I do get the "ADS-B Partial" and/or "No...

So I flew yesterday and the problem did go away airborne, so maybe Dynon was right in my case. I do get the "ADS-B Partial" and/or "No...

I have the same problem. My Avionics shop is trouble shooting now. The problem is intermittent. You can tell me it’s a low altitude...

Excellent Dynon Avionics comm head. Has control knob and buttons for TWR, ATIS, GND, ATC functions. In original box. 200€

Autopilot Control Panel Vertical - 500$ - sold

I am installing complete Skyview HDX suite with EMS. My plane, ( a Berkut with a Lycoming O-360), had a VM1000 EMS from Vision...

Ok, unless you’ve removed the backshells & THEN did a gentle pull test on the wires, you’ll never know if the old cable was the issue...

I did a continuity check on the network cable connected to the problem screen. I really had to dig around in the pin holes to make...

I also have a Stratux, which is usually rock solid. I purchased the black dongle with the antenna for my HDX system as a backup, but...

I have purchased the super neurons from flyingneurons. I used the serialport 4. in the Dynon setup I have chosen the serial in device...

The old adapters/dongles were white and the latest versions are black - either should work ok. If they’re “putting out wifi” you should...

Thanks, I did see in the documentation that it will do as you wrote. My Skyview already puts out wifi with a little usb dongle, am I...