Recent content by 6adan

Thanks, will check this. I should have given more info. RV6A with o320.

WE seem to be getting double what the RPM should be on our Skyview. Can someone give a clue as why we are seeing this. WE checked it with a external rev counter.

Thanks, Now I know what to do.

I am a bit confused about this. On the wiring guide power is supplied to pin 13 but dose not explain where the power comes from. Dose it just come from a switch or somewhere else that I am missing? Thanks Dannie

I know I must have overlooked it but I can't find the installation guide for it. Can someone put me on it? Thanks Dannie

I have everything hooked up to the engine except the red and black wires for the voltage meter. I am not sure where the best place to connect these wires or if the red wire should be fused. It may be in the instructions and I just have not found it yet. Can someone answer this for me? Thanks Dannie

Thanks Tom. Those pages were in a different place in my paper copy of the Installations Manual and were not as clear to me as the ones you gave me. Got it done. Dannie

I guess I am missing something. I can't find where in  the directions for the ADAHRS to place the wires in the D9 where it plugs into the SkyView network. Can someone please tell me where to look?

Thank you, now maybe my head won't explode trying to figure it out.  8-)

When wiring the pitch and roll servos the diagram says the twisted wires can share wires at any point. Now my question is how dose the SV know which servo to tell to go up or down or left or right? I just can't wrap my head around this.

How close can I get to the exhaust flange without causing any trouble? I have a Vetterman exhaust and #3 is very short. I also just found out that I have 1 1/2'' tubes instead of 1 3/4'' I guess this is why it is tighter to the bottom of the engine than the pictures I have seen.

I need to know what kind of tool to use on the engine wire harness? Thanks Dannie

Thank you I did not thank of the vortics on the wingtip.Skysalor I like your idea about the inspection plate that looks like the best place for our planes. Dannie

I will be installing a heated pitot in my 6A but the wings have been compleated and I can't install it like the instruction say.My question is would it be OK to install it in the wing tip?

Thanks everyone for the help. Carl I had not thought about water entering it. I do not plan on flying in rain but never know.Has anyone else had any trouble with water? Dannie