Recent content by bdirdal

I have one HS34 for sale if you still need one regards Borge

Hi I have both EFIS , EMS and AP 74 installed in my panel, I just installed AP and connected GPS signal to pin 22 on the EFIS, just read in the installation guide this suppose to be installed to pin 19 on the EMS when both EFIS and EMS is installed. Do I need to rewire to pin 19 on EMS? Regards...

I plan to install autopilot and already have HS34 modul together with Efis D-100. is it possible to use the HS34 with the autopilot?

Thanks, i will[ch128077]

One more question, I will change out the HS34 with the AP74 module. looks like I can use the same D25 connector to connect to direct to my new AP74 module without changing any pins? Please confirm. Thanks

Thanks

I use the HS 34 to control EDC-D10A compass and nothing else. Can that be done with the AP74?

Hello I do have the HS34 installed together with EFIS D100 as I needed this as exspansion. I plan to install Auto pilot and then need the AP74, can I replace the HS34 with the AP74 and still have the espansion possibillity with the HS74? This due to lack of space in my panel. Regards Borge

Some additional information. DSAB network showing 3 network devices. EFIS D 100 03222 status active HS 34 Status active EMS D120 02020 status offline. Would it help to re-configurere the network ? EMS showing the Dynon logo but none of the hotkeys are working

No, it power up and shows a blue sreen with Dynon logo. Would it help trying to enter the EFIS setup DSAB configuration menu and seartch for the EMS and the HS 34?

I have installed EFIS D100, EMS D120 and HS 34 in my plane since 2010 without pany problems. Yesterday just before take of the engine stopped and when i started again there was no information from the EMS. Only the message on the EFIS D100. EMS MAIN EMS NOT DETECTED Any who can help here...

I have installed Efis D-100 and EMS d-120 together with HS- 34 in my plane. This has been  working fine since installation 2010. Yesterday just before take of the engine stopped and when I started again the EFIS showed the message "EMS MAIN EMS NOT DETECTED like showed on the attached picture...

Thanks,i found a broken wire :)

I have problem with reseting my CHT alarm cyl. 2. after been using heat gun to identify the different probes. Cylinder 2.showing X and I'm not able to reset this and get it showing the temp. I have set the sky view up to clear alarms but this dosen`t clear this alarm. Anybody experience the...