Recent content by Bryant Paulsen

With the airplane weighed, the new weight and balance documents have been laminated, so the PNW weather won't lay waste to them. All of the required logbook entries have been made; including, an entry in the new avionics logbook. The first test flight was flown on July 8th and it was flawless...

You're welcome and I'm glad that this forum was able to help you in your project. I will definitely enjoy all of the upgrades!

Yes, I'm very pleased with the outcomes. The first test flight is scheduled for tomorrow morning.

The project has been completed! Next up: Weigh the 172 for the new weight-and-balance data and perform some Dynon software calibrations. WIP... but almost done!

More progress to share. Almost done...

Six Pack Aero is installing the VGs, too!

I'm glad that you are enjoying the thread! The 5 amp circuit breaker protects the 2-port USB component and the 15 amp circuit breaker is for a cigarette lighter outlet.

Power applied and some initial programming. Sweet!

Firewall forward has been completed. The lower panel wiring has been completed.

More great progress.

Awesome. Thank you.

Indeed, I'm looking forward to this STC; it will be wonderful. Is the in-flight autopilot tuning procedure located in the SkyView HDX System Airplane Flight Manual Supplement? I have not downloaded it yet. Thank you for your feedback.

Lots of progress to see, for I have been away for a while... N22230 has a SureFly left magneto installed, so their tachometer signal converter module was required to be acquired and installed, so that the SkyView could display the appropriate data during a mag check. Power should be applied to...

Cool... the new windshield has been installed. No more peering out of a milky and crazed one when flying into the sun.

Thank you for the heads-up about this issue. I'll keep the panel area free of any stainless steel coffee mugs!