Recent content by Dalon

Hello Michel. The French distributor is Finesse Max in Haguenau. Where is our machine based ?. Bruno

Hello, I have the same problem that Dave H. reported below (constant reboot on startup). My config : D180 with AP74 on the left, D10A on the right. After powering up, the Dynon logo appears for about 4 seconds, then a black screen for about 3 secs, then the Dynon logo again... Most annoying is...

In fact, I found the question of dual D180s had been asked and answered long ago...in 2011 (shame on me) : https://forum.flydynon.com/threads/dual-d180s-possible.3279/ As I finally decided to add a D10A to my D180/AP74/OAT/remote compass config, I now wonder if, after connecting the D10A to the...

Thank you, I am going with the D10A. Bruno

From Rob's message and the message from the gentleman on the Dynon Staff, I understand that : a) 2 EMSes CAN be on the same system (as illustrated in the drawing on page 4-12 of the Flightdeck 180 installation guide REV H, which shows a D180 AND an EMS D10 or D120 on the same bus), but that...

Thanks Rob. I have asked the same question to different people and obtained different answers. And regarding the manual, I must admit it can be a bit confusing at times, at least for me. Thanks for the tip regarding the D100. I had also thought of it but the problem is they seem to be hard to...

Hello, My present config is a D180 with remote compass, OAT sensor and AP74. The D180 is also connected to an AvMap EKPV GPS. Eveything is on the pilot's side of the machine. I am planning to install on the right side either a new D10A or a used D180. My prefered option would be to install the...