Recent content by nobubbles63

Thanks again Ray, When I get a chance to get to the aircraft I'm going to give that a go. Derek

Ray, Thanks for this advice. One final question...having wired into the EMS can you configure the screen warning to show "alt fail" or something similar? Derek

Is there any way to monitor possible alternator failure using one of the contact inputs on the EMS. The Plane Power alternator has a L wire to feed an alternator failure warning light on the panel. Could this be configured on one of the contact inputs (pins 9,10)? As I understand it, the circuit...

Ray, Thanks for your earlier reply to my query back in Sept. Well, when checking those readings as you suggested we eventually found what the problem was...the original builder had labelled the original tank wires back to front so when trying the calibrations with the EMS it all went wrong. All...

I have an flying RV-7A that was fitted with the original Vans resistive fuel level senders which were working fine. last winter I installed an EMS D10 and connected the single fuel sender wires into the unit. Several calibration attempts have failed to work, each time the fuel addition is not...