Recent content by pacecapt

Thanks for the input. I did install it today using one of the GP Pins and set it to the Dynon OAT sensor as a test and the sensor is giving me temps. I do have the range of temps that the sensor supports and will attempt to make a custom definition for it. The sensors temp values are a small...

It is a thermistor style which is the same at the Dynon OAT…

I am considering adding a generic Air Temp sensor inside the engine compartment on my Experimental Aircraft. I have a two wire sensor (like you would use on a Grill) that I would like to connect to my Dynon HDX system. Any recommendations on which leads to connect it? There is currently no...

I have a buddy who has two airplanes one of them has a Dynon Skyview touch system with a Dynon SV-XPNDR-261, both have the latest software. He also has a project plane without a Dynon System but it has a Trig TT-22 Transponder (which needs a software update). If he puts the Trig TT-22 into his...

Thanks, I am aware that Android devices can be purchased fairly cheap but I also have an older Asus Nexus 7 that I am considering trying your system with my Dynon HDX.

Will this work on any Android device? Any limitations? Do you have any recommended devices?

I will give it a try, thanks.

Thanks for the insight. My Dynon WIFI dongles are about 18” from the iPad and my Stratux is 3-4 feet away which also makes me think it is the Dynon and not the iPad or ForeFlight.

Why did Dynon design the HDX system so that you need a separate WIFI dongle for every screen instead of just one dongle for the system? I think this might be the reason that the WIFI disconnects frequently from my iPad running Foreflight. FYI, The same iPad when connected to my Stratux never...

I completed the update last week and also updated the transponder as well. I have not had any traffic dropouts but I am still having issues with the WIFI connection to Foreflight frequently dropping and reconnecting. I thought this SW version was supposed to remedy that problem. And yes the...

I have both a quick disconnect switch (just like addressed in the Manual), very easy to do especially if you already have an unused button on the stick. I also have a fused toggle switch on my panel that will shut off the power to the servos for those times I don't want them on.

I don't know anything about Garmin (other than it is expensive and they don't like to play with others). I do have about 700 hours on my non-IFR Dynon HDX system and I think it is good...not perfect. As you have clearly discovered, Dynon does not make an certified IFR navigator so in order to...

You are also going to need the Dynon SV-ARINC-429 module to connect a non-Dynon product to the system.

Thanks, I am in the process of moving them...I find it very strange that you can only connect one device to the Dynon Wifi. If that is the case then they just should use Bluetooth.

Thanks, I have already purchased the extension cables and will give it a try...just having one device connected didn't fix it.