Recent content by randy737

This is an update on my SV-COM LCD backlight intermittent issue. I sent my SV-COM head back to Dynon and it was repaired under warranty with a three day turnaround. Thanks Dynon for the the excellent service.

I need the P/N of the mount screws that hold my D1000 in the panel. I misplaced some of my screws.

Video sent. In the video at 20 sec you will see LCD backlight flicker, At 45 sec full bright, At 50 sec full dim or off for a bit than full bright.

It happens about one time in ten minute intermittently.It is not reacting to ambient light conditions.It will go from a normal backlight to dim for 20 or 30 sec then back to normal. I will try to get a video

My Dynon SV-COM panel LCD backlight goes bright dim intermittently . COM works good and button backlighting also working OK. Any ideas would be appreciated.

Bruce did you get your transponder back from Dynon? Is it up and working now? I had the same issue with my transponder and sent it back last week.

I have the same problem after transponder (SV-XPNDER-261 SN 02745) software update. I have transponder status "NOT FOUND" and "TRANSPONDER OFFLINE" with serial port-1 tx counter sending data and rx has no data. I switched The transponder to serial port-3 with no help.